12.
Connect the speaker wiring adaptor
and make a small hole in the rubber
grommet. Pass the speaker wires
through the grommet into the door
cavity. Ensure the wiring is kept tight
against to door skin as to not
obstruct the window when lowered
down
13.
Insert the silicon baffle into the
speaker adaptor and line up the
securing holes. (
6.5” version
only)
14.
Connect the speaker spade terminals
to the woofer ensuring the polarity is
correct (Red Po, Black
Negative -) Line up the holes and
silicone baffle and use the screws
provided to secure to the speaker
adaptor
Test the speaker and re-install the
door card. Re-installation is a
reversal of the removal process.
NOTE
Please check the window does
not catch the Speaker on the 8”
kit
when full down. If it does please add
a 2 mm spacer or foam gasket to the
back of the speaker.
Extra Sound
deadening included which can be
fitted under the adapter and
speaker if need (8” version only)
Replacing the Door
Speaker continued…
