15.
To remove the factory tweeter (if fitted)
first use a trim removal tool to remove
the dash cover. Lift the front edge first
and remove completely
16.
Remove the tweeter (if fitted) by
removing the two T15 Torx screws
securing the tweeter mount to the dash
and unplugging the tweeter connector.
Safely retain the mounting screws for
reinstallation
17.
Before fitting the new tweeters, please
make sure the crossover or capacitor is
used to protect the tweeter. (See
Section 21 for details.)
Secure the OPTI1C tweeter to the new
tweeter mount using the metal locking
ring provided.
18.
For vehicles that are not fitted with
factory tweeters in the dash, the OPTI1C
tweeter wires will need to be routed to
behind the stereo. Connect the T Crimp
connecters as shown to the Tweeter
wires and clamp closed using pliers or
similar.
Please make sure the included
crossover is used. This can vary from
the kit order from inline to separate
yellow cap. This should be used on the
positive cable
Replacing the Tweeter T5 kit Dash Board Placement (T6 Fitting See 15B)
Vehicles WITHOUT factory fitted Tweeters
