15B. To gain access the tweeter on the T6
the A pillar needs removing.
A trim tool is recommended to remove
these to avoid breaking anything.
16B. Once removed the Tweeter is now
able to be removed. These are plastic
welded into place from factory and can
easily be removed with the use of heat and
a small amount of pressure.
Please refit in reverse. A glue gun may be
needed at this point
17B. The tweeters are to be fitted into the
original place and plug into the original
position.
These can be soldered and wrapped or use the
supplied Bullet connectors.
See point 20 and 21 for full details.
Note: Failure to complete this step
correctly may result in damage to the
tweeter which is not covered by
warranty.
Replacing the Tweeter T6 A Pillar
T6 with factory fitted Tweeters
