Speaker Installation Guidelines
Speaker Installation
Tweeter Connections
Firstly, make sure that the speakers will fit in your chosen location. This may involve the
removal of the standard vehicle speakers. Please use the mounting depth and hole cut
dimensions as detailed in this manual for guidance.
• If necessary cut any material away to allow the speaker to sit correctly.
• Cut out the mounting hole and pre-drill any other fixing holes.
• Screw through both gasket and speaker until the speaker is securely fastened.
Find a suitable mounting location for the speaker.
Mark the mounting holes and pre drill the fixing hole with a 2mm drill bit. If the grill is to
be fitted then place it over the speaker and screw through both the grill and the speaker
using the provided screws. Be careful not to over tighten the screws as it may cause
damage to the grill.
4
Please follow the wiring diagrams and ensure that correct polarity is observed as
incorrect wiring may cause the speakers to be out of phase with the rest of the system
and result in a loss of bass.
NOTE :
Unless using an active crossover network, the 2.2uf 100v capacitor must be
fitted in order to avoid damage to the tweeter.
2.2uf 100v
Autogoods “130”
130.com.ua
