13
4-2 Corner Error Adjustment
(1) Remove the unit cover (Refer to Figure 5-1).
(2) Replace the pan and pan base and adjust the adjuster so that the balance is
horizontal.
(3) Adjust the corner error according to the following corner error adjustment table.
(Figure 4-2)
To the GZDSP board
Corner error
adjusting bolt (A)
Corner error
adjusting bolt (B)
(Figure 4-1)
Symbols Descriptions
Positive from the center
Negative from the center
Turn the adjusting bolt counterclockwise.
Turn the adjusting bolt clockwise.
