6.3 Parts
Counting
The parts counting function employs an automatic memory update method, also referred to as a
Self Counting System. When you put a specified number of samples on the balance, and put
additional samples, the balance automatically updates the average unit weight of the samples.
However, you cannot add more than three times as many samples as the first reading. This
mechanism allows accurate counting.
6.3.1 Sampling
1 Select the parts counting function.
Select the parts counting function in Function 1
[
].
Put tare on the balance.
2 Start
sampling.
Press the Function key for a few seconds.
When the display indicates [
], release the
key.
The display then blinks [
Pcs].
This indicates to put 10 samples on the balance.
3 Change the number of samples as required.
If the samples vary considerably in size, or are light in
weight, press the Zero/Tare key to change the number
of samples.
Every time you press the key, the value in the right
end is changed. Select an appropriate value.
If you do not need to change the number, skip this
step.
4 Put a sample on the balance.
Put the displayed number of samples on the balance,
and press the Function key.
The display then blinks [
Pcs].
Pcs
M
Continuous press
Changes of the number
Pcs
21
