4
Active O2 Cover:
Top: Knitted polyester
mesh fabric. Sides:
Polyurethane coated nylon
fabric. Bottom: Knitted
polyester mesh fabric.
Active O2 cushion complies with EN1021-1 and
CAL117.
Separate outer covers comply with EN1021-1,
1021-2 and CAL117.
Covers are machine washable.
PRECAUTIONS AND SAFETY
INSTRUCTIONS
A Vicair wheelchair seat cushion may only be
used as a wheelchair seat cushion. The use of
this product in any other way, is considered to
be misuse. Vicair B.V. cannot be held
responsible for damage caused by misuse,
improper use or negligence. Make sure that you
read and understand this manual completely.
Warning!
Vicair B.V. recommends to install the
product under direct supervision of a therapist
or Assistive Technology Professional.
Warning!
Your tailbone and pelvic bones should
not touch the bottom of the cushion. Checking
for “bottoming out” should be done during first
use and after adjustments to the cushion filling.
Warning!
Make sure that your tailbone and
pelvic bones are resting on the rear
compartments with SmartCell liners, not on the
foam inlay.
Warning!
Check your skin regularly for redness,
especially during the first few days. If redness
occurs and does not disappear after 15
minutes, consult your therapist or Assistive
Technology Professional.
Warning!
Make sure the SmartCell liners are
placed in the correct compartment (see
SmartCell liner label).
Warning!
Vicair B.V. recommends to adjust the
filling grade under the direct supervision of
your therapist or Assistive Technology
Professional.
Warning!
In case of soiling with body fluids, and
when transferring the product to another user,
the product must be disinfected to avoid cross
contamination.
Warning!
Every three months, check the
product for wear and deflated cells. In case of
serious damage, or a large number of deflated
cells, do not continue to use the product.
Consult your Assistive Technology Professional.
Caution!
Do not use or leave the product close
to a naked flame or a high temperature heat
source.
Caution!
Do not dry clean, steam clean or
autoclave the product. The product cannot
withstand excessive heat or pressure. When the
given cleaning instructions are not followed, it
is very likely that the product and/or the
product’s cover will age more rapidly.
Caution!
Remove foam inlay before washing
this cushion in a washing machine.
Caution!
Do not use the foam inlay without the
foam inlay liner.
Caution!
Do not use aggressive or abrasive
cleaners, or sharp objects to clean the cushion.
Caution!
Do not place the topside of the Vicair
O2 cushion against the glass of the washer
door.
Caution!
Make sure the cushion cannot
interfere with the wheel spokes.
Caution!
Excessive washing may influence the
aging of this product.
Notice!
Filling grade may slightly deviate from
default (see product label).
INSTALLATION
Warning!
Vicair B.V. recommends to install the
product under direct supervision of a therapist
or Assistive Technology Professional.
Summary of Contents for Active 02
Page 1: ...USER MANUAL ...
