2.Insert the cold point of thermocouple to“ K
Temp”socket
，
put the working end (temperature
measurement end) of thermocouple on the surface or
inside the object to be tested. Then you can read
temperature from the screen, and the data is in
Centigrade .pr
ess “DC/AC” key to select Fahrenheit, the
data is in Fahrenheit.
Note:
1.If insert the thermocouple opposited , it will display the
mistake value ,when the temperature is rising, the value
will be down.
2.when the input terminal open-circuit ,it will display the
normal temperature.
3.Don’t change the temperature probe optionally ,or the
value accuracy isn’t guarantee.
4.Don’t input voltage at temperature range.
4-12
.
Data holding
Press HOLD key, presently measured value is held on
LCD and HOLD symbol displays. press it again ,the
function is cancelled.
4-13
.
Auto power off
1. When the meter stops work about 15 minutes, the
built-in buzzer will be sound 5 times and turn into
sleeping mode, 1 minute later, the buzzer sound a
long voice 1 time, the meter will be power off. Press
any key to restart the power.
2.
Press “DC/AC” key and then turn on, the auto power
off function will be cancelled.
5.
Meter maintenance
1. Don’t input the voltage value higher than DC 1000V
or AC 750V
2. Don’t measuring the voltage at current, resistance,
diode and continuity rage
3. Don’t use the meter when the battery isn’t install or
the back case isn’t firm.
4. When replacing fuse, please take away the test leads
from the measuring point and power off at first.
5. Keep the meter away from water, dust and shock.
6. Do not store and operate the meter under the
condition
of
high
temperature,
high
humidity,
combustible, explosive and strong magnetic place.
7. Wipe the case with a damp cloth and detergent; do
not use abrasives and alcohol.
8. If do not operate for a long time, should take out the
battery to avoid leakage.
9.
When”
” symbol displays, should replace the
battery following the steps:
9-1. see picture 2, move holster at first.
9-2.Unlock the button and remove the battery case;
9-3. Take out the old battery and replace the new one.
It's better to use alkaline
battery for longer life.
9-4.fit on battery case and bolt.
9-5,see the picture to fit on the
holster.
10. Fuse change: When
replacing fuse, please change
another same type and specification fuse.
6. Trouble shooting
If the meter does not work properly, check the meter
as following:
Fault
Solution
No reading on LCD
Turn on the power
Replace battery
signal appears
Replace battery
No current or
temperature input
Replace fuse
Big error Value
Replace battery
ACV big error value
The voltage was
measured frequency
higher than 400Hz
The specifications are subject to change
without notice.
The content of this manual is regarded as
correct , error or omits Pls. contact with
factory.
We hereby will not be responsible for the
accident and damage caused by improper
operation .The function stated for this User
Manual cannot be the reason of special
usage.
E-VC99/V1.0
Prepared: http://digitalchip.ru
