49
– Enable time folder:
Create the folder in the FTP Server.
* Time type:
User can set the name of the folder where the uploaded image will be saved
as the date, time and minute the event occurred.
• JPEG Setting:
– Pre-event:
A pre-event buffer contains images from the time immediately preceding the
event trigger. These are stored internally in the server. This buffer can be very useful when
checking to see what happened to cause the event trigger. Enter the desired total length in
seconds, minutes or hours, and specify the required image frequency.
– Event:
This function can set required image frequency (1 ~ 2fps) when event detected.
– Post-event:
This function is the counterpart to the pre-trigger buffer described above and
contains images from the time immediately after the trigger. Configure as for pre-event.
– Prefix file name:
This name will be used for all the image files saved. If suffixes are also
used, the file name will take the form <prefix> <suffix>.<extension>.
– Additional suffix:
Add either a date/time suffix or a sequence number, with or without a
maximum value.
When the settings are complete, click
Save
button to save the settings, or click
Reset
button to
clear all of the information you entered without saving it.
▽
Alarm Out
When the network camera detects an event, it can control external equipment connected to its
alarm output port.
• Enable alarm out:
If selected, the output becomes activated for as long as the event is active.
• Type:
Select a type of NO (Normally Open) or NC (Normally Closed).
When the settings are complete, click
Save
button to save the settings, or click
Reset
button to
clear all of the information you entered without saving it.
Summary of Contents for Cruiser SN673V-C
Page 2: ......
Page 86: ...85 3 7 About Learn information about your system from the About screen ...
Page 92: ......
