Technical Support Document
http://www.vicon-security.com
US Support
support@vicon-security.com
1-800-348-4266, ext. 5
EMEA Support
EMEAsupport@vicon-security.com
+44 (0)1489 566330
Connecting to an iSCSI RAID
This guide covers configuration of the iSCSI initiator within the Windows PC (Kollector/NVR) and an iSCSI RAID. It shows
initially how to connect the two units together but may be equally helpful when reconnecting or fault finding.
For best performance the iSCSI RAID should be connected via a dedicated network shown in Red below.
NOTE: IP Addresses shown are for guidance only. Please check the Network settings on each device before proceding as they may be different.
Go to Control Panel and
start the iSCSI Initiator
Click on Discovery, Discover Portal.
And then Advanced.
