Chapter 6
Maintenance
Periodic checking and maintenance of certain parts of your Kollector will minimize future system problems.
The following table lists the items that need to be checked and when.
Maintenance Required
Monthly
Annually
Cleaning the filter (Kollector
Force only)
9
Backing up
9
Checking the front and rear
fans
9
To clean the filter on the Kollector Force:
1. Turn the Kollector Force off, and then open the front door.
2. Open the filter housing on the left-hand side.
3. Carefully remove the old filter, and then wash it under running water with a mild soap.
4. When the filter is completely dry, return it to its place in the Kollector force.
5. Close the filter housing.
6. Turn the Kollector Force back on, and then close the front door.
To check the fans:
1. Turn the Kollector off. On the Kollector Force, open the front door.
2. Open the filter housing on the left-hand side.
3. Carefully remove the filter, look at the front fan and ensure it is operating properly.
4. Look at the fan in the rear of the Kollectors and ensure it is operational.
5. When you have finished, replace the filter on the Kollector Force, turn the Kollector back on and then
close the front door.
To back up the Kollectors:
•
Refer
to
Chapter 3, Configuring the ViconNet System
in the
Kollector Software Manual.
NOTE: The backup procedure should be performed whenever a change is made to the system settings.
CAUTION: Do not open the recorder’s top cover for any reason. Failure to follow this instruction can result
in serious injury to the user and void the manufacturer’s warranty.
XX112-06-01 Rev 911 Kollector Network Digital Video Recorders
Maintenance
•
25
