B E Y O N D M O T I O N
Page 8
Vicon Motion Systems
•
•
•
•
•
•
•
•
•
•
Product configurations and software options - Vicon Lock+
This page provides information relating to the EU Declaration of Conformity (Vicon Lock+)
Conformity of the Metrological Performance of CLASS 1 Products
Manufactured in Accordance with Annex VII, Section 5 of the
Medical Devices Directive 93/42/EEC of the 14
th
June 1993.
As amended by EU Council Directive 2007/47/EC of 5
th
September 2007.
We, Vicon Motion Systems Limited
Unit 6, Oxford Industrial Park
Mead Road, Yarnton, Oxford, OX5 1QU
declare that the VICON Lock+ providing analogue-digital conversion within the VICON Vantage or Vero Gait Analysis System manufactured by VICON MOTION
SYSTEMS LIMITED has been tested prior to shipment and meets the following metrological performance:
Measurement Criteria
Supporting software: Nexus 2.10 or later, Shogun 1.4 or later, Tracker 3.8 or later.
Analog Digital Conversion
Resolution to ± 10 mV mean and ± 10 mV (1 Standard Deviation).
Synchronization
Difference within one video frame.
Lock+ safety information
The following guidance helps you to ensure the safe operation of your Vicon system, including the use of Lock+.
To avoid introducing a safety hazard and possibly damaging the system, please ensure that an adequate and good-quality alternating current (AC) power source
is available.
For guidance, see the ratings statement on the rear of the connected PoE or PoE+ unit. Also ensure that any computers and peripheral devices are set to be
electrically rated to operate with the AC power available in your location.
When working with Vicon systems, observe these safety precautions:
To prevent electric shock, plug all system components into properly grounded power sources. These cables must be equipped with three-prong plugs to
ensure proper grounding. Do not use adapter plugs or remove the grounding prong from a cable.
Ensure nothing rests on the system cables and that cables are not located where they can be stepped on or tripped over.
Do not spill food or liquids onto any electrical component of the system. If any component gets wet, immediately contact Vicon Motion Systems or your
nearest agent or distributor for advice.
Do not push any objects into the slots of any unit of the system. Doing so can cause fire or electric shock by shorting out internal components.
Keep all system components away from radiators and heat sources, and do not block cooling vents. Avoid placing loose papers underneath any components.
Do not place any components on closed-in units or on a bed, chair, etc.
Replace fuses with the same type and rating for continued fire protection.
Do not use outside, near water, in an environment exposed to anesthetic or other explosive gases, or in mobile applications.
Warranty information
The warranty for your Vicon system begins after installation. For full details on warranty scope and conditions, refer to the Vicon Terms and Conditions of Supply
for your Vicon system.
If you need more information than that supplied in the documentation or
on the
, please contact Vicon:
Denver, CO
Vicon Denver
7388 S. Revere Parkway
Suite 901, Centennial
CO 80112, USA
T: 303.799.8686
F: 303.799.8690
E:
Los Angeles, CA
Vicon LA
3750 S. Robertson Boulevard
Suite 100, Culver City, Los Angeles
CA 90232, USA
T: 310.437.4499
E:
Oxford, UK
Vicon Oxford
Unit 6, Oxford Industrial Park
Mead Rd, Yarnton, Oxford
OX5 1QU, United Kingdom
T: +44.1865.261800
E:
© Copyright 2021 Vicon Motion Systems. All rights reserved.
