Creating a Configuration
|
3-41
Pilot Plus
XX200-00
Alarm Input Controls
The Alarm Input Controls screen controls the X-IA and RS-232 alarms only.
Up to 128 alarms are available. The Pilot Plus has built-in X-IA alarms. RS-
232 alarms are serial data outputs to compatible devices, such as computers
and printers.
To be processed, X-IA alarm inputs must be enabled. X-IA alarms may be
enabled in groups referred to as patterns. Three patterns are available (A, B
and C). The use of patterns allows X-IA alarms to operate as a group. For
example, an Alarm Enable event using pattern A could be scheduled for
daylight hours and pattern B could be reserved for night. Refer to the
Admin
section,
Timed Events
for more information.
Note:
X-IA alarms should be used for critical surveillance areas rather than
receiver alarms.
You can set the actions for each alarm input by selecting it in the single-
column list on the left. The alarm input number will be displayed in the 4-
column table. The field columns and their actions are described in the
following table. A description of each field parameter is displayed on the
screen when the field is selected.
Summary of Contents for PILOT PLUS V1544
