8
•
Installation
XX163-11-00 Rev 1006 SVFT-PRS Pressurized Dome Housing
Preparing the Camera Drive
18. Open the box containing the camera drive assembly and remove it.
Setting the DIP Switches
19. Holding the drive upside down, set the DIP switches for proper address and configuration as shown
below. Refer to SurveyorVFT Installation and Operation manual XX134 for details on setting the DIP
switch.
Competitive Protocol Settings, Switches 5-8
Pelco:
Switch 5 is ON, switches 6-8 are OFF
Sensormatic:
Switch 6 is ON, switches 5, 7, 8 are OFF
Ultrak:
Switches 5 and 6 are ON, switches 7-8 are OFF
Philips:
Switch 7 is ON, switches 5, 6, 8 are OFF
Cohu:
Switches 5 and 7 are ON, switches 6 and 8 are OFF
Kalatel:
Switches 6 and 7 are ON, switches 5 and 8 are OFF
Panasonic:
Switches 5 and 8 are ON, switches 6 and 7 are OFF
NTCIP:
Switch 8 is ON, switches 5 - 7 are OFF
For example:
To set DIP SWITCH SW1 for Address 1:
1 - ON, 2 - OFF, 4 - OFF, 8 - OFF, 16 - OFF, 32 - OFF,
64 - OFF, 128 - OFF
DIP SWITCH S2 typical configuration:
1 - ON (NTSC), 2 - OFF (Serial), 3 - OFF (DUPLEX),
4 - OFF (RS-422), 5 through 8 - OFF (Vicon VPS)
Summary of Contents for SVFT-PRS22E
Page 2: ......
Page 16: ...10 Installation XX163 11 00 Rev 1006 SVFT PRS Pressurized Dome Housing...
Page 31: ......
