MOUNTING ACCESSORIES
Corner Mounting Bracket
1. Secure the corner mounting bracket to the
structure with eight
lag screws or
hex bolts (or studs), using the appropriate
dimensions shown on Figure 2.
2. Secure the wall mount base plate to the
face of the corner mounting bracket with four
hex bolts, nuts, and washers.
Support
Strut
To install directly to a wall surface:
1. Detach the end cap from the installed wall
mount by removing the three screws.
2. Slide the
bolt (supplied) into
the groove (8, Figure 3) at the bottom
of the wall mount.
3. Loosely attach the front end of the strut
to the bolt with the nut (supplied).
4. Align the rear end of the strut to the
correct wall location using the appropriate
dimensions shown on Figure 2 and mark the
wall at that point.
5. Secure the support strut to the mounting
location with a
fastener or anchor,
following the recommendations in the General
Instructions. Tighten both bolts.
6. Replace the end cap and three screws.
To install the strut to a corner:
1. Secure the corner strut bracket to the
structure using four
bolts (or
studs), following the recommendations in the
General Instructions and using the appropriate
dimensions shown in Figure 2.
Figure 1
Wall Mount
2
X417-988
