37
Sensitivity level [1-100]:
The default level is 80, which means that if 20% or more sampling pixels
are detected differently, system will detect motion. The bigger the value,
the more sensitive it is. However, when the value is larger, the red
horizontal line in the motion indication window will be lowered
accordingly.
Time interval (sec) [0-7200]:
This value is the interval between each detected motion. The default
interval is 10.
Triggered Action (Multi-option)
The administrator can specify alarm actions that will take when motion is
detected. All options are listed as follows.
Enable Alarm Output
Check the item and select the predefined type of alarm output to enable
alarm relay output when motion is detected.
Record Video Clip
Check this item and select a video recording storage type, <SD Card> or
<NAS> (Network-Attached Storage>. The Motion Detection recording
will be stored in microSD/SDHC card or the NAS when motion is
detected.
<Pre-trigger buffer> recording function allows users to check what
caused the trigger. The pre-trigger buffer time range is from 1 to 3
seconds. Select <Upload for __ sec> to set the recording duration after
motion event occurs. The setting range is from 1 to 99999 seconds.
Select <Upload during the trigger active> to record the triggered video
until the trigger is off.
NOTE:
Please make sure the local recording (with microSD/
SDHC card) or the remote recording (with NAS) is activated so
that this function can be implemented. Refer to section
Recording
for further details.
