59
2.2.11 Schedule
The Schedule setting can be found under this path:
System> Schedule
.
This function allows the users to setup schedules for features including: <Alarm
Switch>, <Motion Detection>, <Network Failure Detection> and <Tampering>.
The function supports up to 10 sets of time frames in the time frame list.
Setting Schedules
To set a schedule, select a time frame from the time frame list first. Then check
the boxes below to choose the specific weekdays. Lastly, type in the start time
(hour:minute) and the duration time (hour:minute) for activation of the schedule
triggered features. The setting range for the duration time is from 00:00 to
168:59. Click <Delete> to delete a chosen time frame. Please click on <Save>
to save the setup.
NOTE:
Users
MUST
select <By schedule> under each feature setting
page to enable the schedule function.
