background image

   VC-620 AND VC-620C

ENVIRONMENTAL HOUSING CAMERA

       About this manual

      Dimensions : inch (mm)

  INSTRUCTION MANUAL XX167-00

Before installing and using the camera, please read this manual carefully.
Be sure to keep it handy for later reference.

TROUBLESHOOTING

Before sending the camera out for repair, check the items
below. If the problem persists  after checking these items,
contact your service center.

 If no image appears

     Is the coaxial cable attached securely?
     Are the power and voltage normal?
     Has the iris of the lens inside the camera been
     adjusted correctly (with the level volume) ?
     Is there adequate illumination?

 If the image is unclear

     Is the lens in focus?
     Is the lens dirty?
     Dirt or fingerprints on the lens can adversely affect the
     images. Gently wipe any dirt or fingerprints off the lens
     with a soft cloth or lens cleaning paper and cleaning
     fluid (commercially available).
     Is the monitor adjusted correctly?

 Do not open or modify

Do not open the case except during maintenance and
installation, as it may be dangerous and cause damage.

 Do not put objects inside the unit

Make sure that no metal objects or flammable substances get
inside the camera. It could cause fire, short-circuits or
damage.

 Be careful when handling the unit

To prevent damage, do not drop the camera or subject
it to strong shock or vibration.

 Install away from electric or magnetic fields.

 Protect from humidity and dust.

 Protect from high temperature

Be careful when installing close to the ceiling , in a kitchen or
boiler room, as the temperature may raise to high levels.

 Cleaning

Dirt can be removed from the case only by wiping it
with a soft cloth moistened with a soft detergent solution.

 Mounting Surface

The mounting surface material must be strong enough to
support the camera.

PRECAUTIONS

SPECIFICATION

GENERAL Spec

NTSC

PAL

CCD Type

1/3" 410K Pixels Color

1/3" 470K Pixels Color

Total Number of Pixels

811(H) x 508(V)

795(H) x 596(V)

Light Sensitivity

Video Output

10Vp-p/75ohm Composite

Resolution

S/N Ratio

Shutter Speed

1/60s - 1/100,000s

1/50s - 1/100,000s

Sync System

Internal / External (Line Lock)

White Balance

DIP Switch Select (AWB / ATWV)

Connector

Power Input

Power Leads

Video Output

BNC Cable

Electrical Spec

Voltage 

12VDC(11-20V) or 24VAC(20 - 27V)

Power Consumption

12VDC : LED (ON:7.5W OFF:2.5W)

24VAC : LED (ON:7.1W OFF:2.1W)

Mechanical Spec

Lens

3.3-12mm

Dimension (Diam x L)

3.0 x 8.2 inch (76.0 x 209.5mm)

Weight

1.81b (795g)

Operation Temp

 14

˚

F ~ 131

˚

F (-10

˚

C ~ +55

˚

C)

In Storage Temp

 -4

˚

F ~ 158

˚

F (-20

˚

C ~ +70

˚

C)

Operation Humidity

Under 90% (Non-condensing)

COLOR - 0.028fc (0.3lux)

BW - 0.009fc (0.1 lux)

550TV Lines

48dB or more (AGC off)

Summary of Contents for VC-620

Page 1: ...e Be careful when handling the unit To prevent damage do not drop the camera or subject it to strong shock or vibration Install away from electric or magnetic fields Protect from humidity and dust Protect from high temperature Be careful when installing close to the ceiling in a kitchen or boiler room as the temperature may raise to high levels Cleaning Dirt can be removed from the case only by wi...

Page 2: ...tire image is too dark or bright or the backlight used compensation is not correct even after is set to ON you need to adjust the level volume IR LED Connector Option CCW Low Closes the lens iris making the entire image darker If extra IR LED board is attached this connector is used CW High Opens the lens iris making the entire image brighter Setting Monitor Synchronization DC Varifocal Connector ...

Page 3: ... more than 360 2 Do not twist more turns than necessary CAUTION To ensure that the cable does not break when positioning the unit provide a slack loop during cable installation To open the external case before making camera settings 1 Remove the 3 setscrews with the tool provided 2 Pull the camera mechanism out of the case 3 Make required adjustments and settings ...

Page 4: ... New Territories Hong Kong 852 2145 7118 Fax 852 2145 7117 Internet Address www vicon cctv com Vicon Industries Inc Corporate Headquarters 89 Arkay Drive Hauppauge New York 11788 USA 631 952 CCTV 2288 800 645 9116 Fax 631 951 CCTV 2288 European Headquarters Brunel Way Fareham PO15 5TX United Kingdom 44 0 1489 566300 Fax 44 0 1489 566322 Vicon Part number 8009 8167 00 01 Rev106 ...

Reviews: