MANUAL RECORDING
When the
END” of the “FIRST TIME SET UP” menu is set to “REPEAT” or
and the repeat recording mode is
set (the REPEAT indicator is illuminated), the tape will automatically be rewound to the start when the tape end is reached. Then
recording will start again.
n
WHEN TAPE END IS REACHED
When there are alarm
recordings on tape.
When there are no
alarm recordings on
tape.
The tape stops.
The tape stops.
The tape is rewound
The tape is rewound
automatically to the
automatically to the
The tape is rewound
beginning and then
stops.
is resumed.
beginning and then the
recording is resumed.
l
On
mode, a tape with alarm recordings can be used for repeat recording if the tape is ejected and re-inserted.
Displays the number of tape use when the TAPE END setting is set to “REWIND”, “REPEAT” or “ALARM*
1. Press the DISPLAY button. MAIN MENU display will appear.
2. Turn the JOG dial to select “MAINTENANCE” and turn the SHUTTLE ring to the right.
“MAINTENANCE” will appear on the display. “REPEAT REC TIMES” indicates the number of times a
tape has been repeatedly recorded on.
l
The number of tape uses counts up by one when the tape ends.
l
The number of tape uses is retained even if the AC Power is disconnected, provided that the back up is fully charged.
l
The number of tape uses is reset when the tape is ejected and re-inserted.
3. Press the DISPLAY button. The present time will be displayed.
Video tape becomes worn during use. A new cassette should be utilized according to the following chart.
Series recording is possible if two or more of these units are connected together. When the tape in the first VCR reaches the end
during recording, the tape in the second VCR automatically begins recording.
1. Set the “REC IN” of “REAR TERMINAL” menu to “SERIES.”
2. Set the “CALLOUT” of “REAR TERMINAL” menu to “WRNG*TAPE END.”
3. Set the ‘TAPE END” of “FIRSTTIME SET UP” menu to “REWIND.”
l
Series recording may have a short pause
5 seconds) when going from
to recorder
However, if you set CALL OUT of
the “REAR TERMINAL” menu to
this delay is eliminated.
l
When set in the above configuration and the second VCR reaches the end of the tape, the first VCR automatically begins recording.
Do not connect
if you do not require the first VCR to begin recording again.
l
If an abnormality occurs (e.g., a malfunction occurs in the motor during recording) in the first VCR, the second VCR automatically
begins recording.
l
Series recording will not function during timer recording.
l
When carrying out series recording, set “CALL OUT” in the “REAR TERMINAL” menu to a mode other than
2 0