WARNING DISPLAY
The VCR uses a self diagnostic function to detect internal malfunctions during recording. Should a malfunction occur during recording,
a corresponding indication appears on the monitor screen and the fluorescent display.
The type of malfunction corresponding to the indication, and countermeasures, are given below.
REMEDY
TO TURN
INDICATION
.
End
Turn off the indication on the fluorescent
TAPE END
THE TAPE ENDS
Rewind the tape and
ING RECORDING
press the EJECT button.
display and on the screen by pressing
the EJECT button or rewinding the tape.
NO SIGNAL
LACK OF VIDEO SIGNAL
Check for loose
When a video signal is restored or the
INPUT (NOTE 1)
tions.
record mode is cleared, the indication
the screen turns off.
check the cassette. If there seems to be nothing wrong
CHECK
the cassette, try the recording operation again. If the indication
TAPE/ DECK TROUBLE
“CHECK” is still displayed, change the cassette with a new one and
I
try the operation again. Otherwise, unplug the power cord and
contact your dealer.
1. Lack of video input signal.
If the VCR is set to record and an input signal is not detected, the indication NO SIGNAL appears on the monitor screen and the
CALL signal is output from the rear terminal.
Check that the cable from the camera is not broken and the camera’s power has not been lost.
3 1
