FEATURES A ND FUNCTIONS
REAR VIEW
WARNING:
The included power cord is used for
Never connect to any outlet or power supply having a different voltage or frequency.
Ensure the power cord is not plugged into the AC outlet before making any rear terminal connections.
AC power socket
CALL OUT terminal
This socket connects to the power cord. Insert the cord
Output terminal to indicate when tape has finished
firmly.
recording or if there has been a problem during recording.
SET IN terminal
RESET button
Input terminal for alarm recording. The alarm sensor is
When pressed, the present time, alarm recording list, power
connected here.
loss list and the number of tape use will be erased. While
(RESET) IN terminal
Input terminal to stop alarm recording when “ALARM REC
DURATION” of the “RECORDING SET UP” menu is set
to
The alarm reset switch is connected here.
the button is pressed, the power is cut off from the VCR. If
there is a tape in the VCR and the button is released, the
power indicator will light and the tape will fast forward for a
few seconds. The VCR will then switch off.
This terminal can also be used to set the on-screen clock
S-VIDEO OUT connector
when set to any mode other than
Output connector for video signal. (S-VIDEO connector)
REC IN terminal
S-VIDEO IN connector
Input terminal to start/stop recording. Also, use this
terminal for series recording
or synchronous
recording (P.23).
Input connector for video signal. (S-VIDEO connector)
REMOTE jack
GND (GROUND) terminal
When a lead connected to other terminals requires a
ground, connect the ground lead here.
ALM (ALARM) OUT terminal
Output terminal to indicate alarm recording to an external
alarm.
Remote control is possible by connecting the optional
remote control unit (VCR-4RC) here. Refer to page 36.
VIDEO OUT connector
Output connector for video signal (BNC connector). If the
power switch is turned OFF, the signal from the VIDEO
IN connector is looped out to this connector.
MODE OUT terminal
IN connector
Input connector for video signal (BNC connector).
Output terminal to indicate the VCR’s mode of operation
which can be selected by setting the “MODE OUT” on
the “REAR TERMINAL” menu.
Audio output connector (RCA pin).
CLK (CLOCK) OUT terminal
IN connector
Output terminal to control an external camera switcher.
Audio input connector (RCA pin).
MIC IN jack
Input jack for a Microphone rated at 600 ohms impedance.
10