SETTING THE MENUS
I
<RECORDING SET
DALARM REC MODE
ALARM REC DURATION
EMERGENCY REC
REC MODE
SETTING THE ALARM REC MODE (ALARM REC MODE)
Sets the alarm recording time mode. When the JOG dial is turned, the display will be switched in
the order of 2H ) 6H
)
2H
2 SETTING THE ALARM REC DURATION (ALARM REC DURATION)
Sets the duration of the alarm recording period. When the JOG dial is turned, the display will be
switched in the order of 1 M(minute) 2M ) 5M
) MAN1 MAN2
)
) 1 M ) . . . .
Refer to “ALARM RECORDING” on page 27.
3 SETTING THE EMERGENCY REC (EMERGENCY REC)
Sets the emergency recording mode.
OFF: Starts alarm recording when the alarm signal is received during recording.
ON:
Starts alarm recording when the alarm signal is received not only during recording but also when the power is OFF or
when the tape is stopped.
4 RECORDING MODE (REC MODE)
Sets the recording mode.
: Choose when higher picture quality is preferred. With this setting, the recording time mode is switched in the
order of 2H
) 48H ) 72H ) 96H ) 120H ) 168H 240H 360H
720H ) 960H )
OH ) 2H . . .
:
Select a EP setting to perform High Density recording. This provides 3x more fields than Normal Density (SP).
It reduces the time interval between pictures, providing more pictures for smoother time lapse recording. With
this setting, the recording time mode is switched in the order of 6H )
48H ) 72H 96H 120H
168H ) 240H 360H
) 720H ) 960H )OH 6H . . .
5
SETTING THE NUMBER OF FIELDS IN ONE-SHOT RECORDING (ONE
Sets the number of fields to record in the One-Shot mode. When the JOG dial is turned to the right, the display will be
switched in the order of 1 ) 2 3 4 5
20 30 ) 1
6 SETTING INTERVAL TIME IN ONE-SHOT RECORDING (ONE SHOT-INTERVAL)
Sets the interval time in the One-Shot mode. When the JOG dial is turned to the right, the display will be switched in the order
of SHOT
(second)
)
)
1 M ) 2M 3M SHOT
1
SETTING THE CALL SIGNAL OUTPUT AT THE END OF THE TAPE (CALL OUT)
Enables or disables the signal that is output from the CALL terminal when the end of the tape is
reached during recording. If any abnormalities occur during recording, a CALL signal is output from
the CALL terminal on the rear panel regardless of CALL OUT setting.
END:
A signal is output at the end of the tape or when a malfunction occurs.
The signal is output when a malfunction occurs in this VCR or when the
tape has approximately 3 minutes left in 2H mode.
WRNG:
When a malfunction occurs in the VCR during recording, a CALL signal is
output.
TERMINAL>
DCALL OUT
REC
REC IN
SERIES
This is used in conjunction with TAPE END (FIRST TIME SET UP) to determine when the CALL signal is output as shown below.
STOP
END
WRNG
Outputs a call signal at
Outputs 3 minutes before
When a malfunction occurs in the VCR
the end of the tape
the tape end
during recording, a call signal is output.
REWIND
Outputs a call signal at the end
of the tape for 2 seconds
t
t
REPEAT
t
t
t
When there are no
ALARM
alarm recordings
t
t
during recording
t
. PROT
When there are
Outputs a
at the
recordings during
end of the tape
recording
1 4