XX176-00-00 Rev 507 VNCTRL-1 Remote Control Panel
Chapter 2 - Installation
•
13
ViconNet Setup
It is necessary to install a software driver to enable the remote control. The minimum driver requirement is the
ViconNet driver, revision 912. All later revision drivers will also support remote control operation. The driver
must be installed prior to hardware connection. Refer to Vicon manual XX113-56 or later for details on driver
installation.
ViconNet is setup to use the remote control in Main Settings RS232/422/485 Controls. The COM port is
configured in ViconNet Setup, selecting the available COM port for the PC
and
the “Internal COM Address”,
which is remote control address programmed in the remote control.
The internal comport must not conflict
with any camera addresses. Baud rate is usually 9600 baud.
●
The
Baud Rate
and
COM Address
(9600 and 1 in screen example below) in ViconNet and VNCTRL-1
should match.
NOTE: COM address can be any address 1-64. When setting address, make sure it does not conflict with a
camera PTZ address.
●
For the 2
nd
generation KE back panels: Under
Port
COM 1 must be selected.
●
For the 1
st
generation KE back panels: Under
Port
COM 2 must be selected.
●
For the VN-NVR back panel: Under
Port
COM 1 must be selected.
Note: The V422-CONV RS-422 to RS-232 converter must be used and plugs into the open COM port on rear
of the Kollector as illustrated in Figure 2-3.
Note: Do NOT check the box for Auto start.
Sample ViconNet Setup Screen
Do NOT check
Summary of Contents for VNCTRL-1
Page 2: ......