http://www.vicsign.com
User manual of HWQ series vinyl cutter
19
/
29
e Pause function
During plotter output, press the “Off line / Pause” button, the plotter will be in suspended state and displays the
coordinates of the current document processing parameters. As shown:
f Setting the origin
The lower right corner as the absolute origin of the media, the user can be set based on their own to the
appropriate position, after moving off a good bit about setting up/down and left/right keys, press the "Origin"
button coordinates cleared, the new origin is set up, carving output from the knife from the new origin.
g Media test strip debugging
Locate the position of car and media, press "Test" button, the machine will automatically cut out a square and
triangle, and tear-out the test strip by hand, if can be easily opened, and not carved through the adhesive,
indicating that debugging is good, if tear-out with the associated media, you need to increase the blade pressure
or adjust the knife extended tip, then continue to press "Test", the machine will automatically cut the left side of
the original location of test strips, you need to do this before you testing well.
