WARNING
• Handrails must be installed and the
electrical cord/safety foot switch cord
must be routed through the support
base(s) to prevent tripping hazards.
Failure to follow this instruction could result
in serious personal injury.
16. Insert the power cord for the safety foot
switch up through the support base(s).
Plug the safety foot switch cord into the
receptacle on the side of the tool by
aligning the pins/tab of the male adapter
plug with the receptacle. Tighten the
locking ring on the plug.
17. Install the platform onto the support base.
Align the holes in the platform with the
holes in the support base, as shown above.
Repeat this step for the other side of the
tool.
Lock Washer
(16 Total)
Hex-Head Bolt
(16 Total)
Handrail Base
(8 Total)
Platform
(2 Total)
Handrail
(4 Total)
Hex Nut
(16 Total)
18. Install a handrail base onto the platform
at the eight locations on the platform/
tool support. Make sure the holes in the
handrail bases align with the holes in the
platforms/support base and that the set
screws on the handrail bases face away
from the platform, as shown above.
18a. Install a hex-head bolt through the handrail
base and into the platform/tool support.
Apply a lock washer and hex nut onto the
end of each hex-head bolt.
TM-VE460_15
TM-VE460
OPERATING AND MAINTENANCE INSTRUCTIONS MANUAL
www.victaulic.com
VICTAULIC IS A REGISTERED TRADEMARK OF VICTAULIC COMPANY.
REV_A