6. Remove the slide spacer by snapping it out
of the tool head, as shown above.
7.
Pull the
“STOP”
knob on the control panel
to the out position.
8. Push the
“HYDRAULIC PUMP START”
button to retract (raise) the slide.
9. After the slide is retracted (raised)
completely, push down (in) on the red
“STOP”
knob on the control panel.
10. Turn the power switch on the side of the
tool to the
“OFF”
position.
TM-VE460_40
TM-VE460
OPERATING AND MAINTENANCE INSTRUCTIONS MANUAL
www.victaulic.com
VICTAULIC IS A REGISTERED TRADEMARK OF VICTAULIC COMPANY.
REV_A