REPLACING HYDRAULIC OIL AND FILTER
Replace the hydraulic oil and oil filter annually
or every 2000 hours of operation, whichever
comes first.
1.
Raise the hood of the tool.
2. Locate the two brackets that hold the oil
reservoir to the frame.
3. Loosen the screws on the bracket closest
to the drain plug. Remove the bracket and
set it aside.
4. On the other bracket, loosen and remove
the screw on top of the reservoir. There is
no need to loosen the screw that holds the
bracket to the frame.
5. Remove the fill/vent plug from the top of
the reservoir.
6. Slide the reservoir partially over the side of
the tool. DO NOT disconnect any electrical
or hydraulic lines.
7.
Position a container underneath the drain
plug. Make sure the container is large
enough to hold 2 gallons/8 liters of oil.
TM-VE460_48
TM-VE460
OPERATING AND MAINTENANCE INSTRUCTIONS MANUAL
www.victaulic.com
VICTAULIC IS A REGISTERED TRADEMARK OF VICTAULIC COMPANY.
REV_A