5. Inspect the equipment.
Before using the
tool, check all moveable parts for any
obstructions. Make sure guards and tool
components are installed and adjusted
properly.
6. Prevent accidental startups.
Place the
switch on the side of the tool to the “OFF”
position when the tool is not in use.
7. Wear proper apparel.
Do not wear loose
clothing, jewelry, or anything that can
become entangled in moving parts.
8. Wear protective items when working with
tools.
Always wear safety glasses, hardhat,
foot protection, and hearing protection.
9. Stay alert.
Do not operate the tool if you
are drowsy from medication or fatigue.
Avoid horseplay around the equipment.
10. Keep visitors away from the immediate
work area.
All visitors should be kept a safe
distance from the equipment at all times.
11. Keep work areas clean.
Keep the
work area around the tool clear of any
obstructions that could limit the movement
of the operator. Clean up any oil or other
spills.
12. Secure the work, tool, and accessories.
Make sure the tool is stable. Refer to the
applicable “Tool Setup” section.
13. Support the work.
Support long pipe
lengths with a pipe stand that is secured to
the floor or the ground.
14. Operate the tool only with a safety foot
switch.
The power drive must be operated
with a safety foot switch that is located for
easy operator access. Never reach across
moving parts. If the tool does not contain a
safety foot switch, contact Victaulic.
15. Keep hands and tools away from grooving
rolls and stabilizer roller during the
grooving operation.
Grooving rolls can
crush or cut fingers and hands.
16. Do not reach inside the pipe ends
during tool operation.
Pipe edges can be
sharp and can snag gloves, hands, and
shirt sleeves. Fingers and hands can be
crushed between the pipe and lower roll.
17. Do not over-reach.
Maintain proper footing
and balance at all times. Make sure the
safety foot switch is easily accessible for
the operator.
18. Do not force the tool.
Do not force the tool
or accessories to perform any functions
beyond their capabilities. Do not overload
the tool.
19. Do not operate the tool at ram speeds
exceeding those specified in this manual.
20. Do not abuse the foot switch cord.
Keep
the cord away from heat, oil, and sharp
objects.
21. Always turn off the main power supply
to the tool before servicing the tool.
Only
authorized personnel should attempt to
perform maintenance on the tool. Always
turn off the main power supply to the tool
before servicing or adjusting the tool.
22. Maintain tools with care.
Keep tools clean
at all times to ensure proper and safe
performance. Follow the instructions for
lubricating tool components.
23. Use only Victaulic replacement parts
and accessories.
Use of any other parts
may result in a voided warranty, improper
operation, and hazardous situations.
24. Do not remove any labels from the tool.
Replace any damaged or worn labels.
TM-VE460_5
TM-VE460
OPERATING AND MAINTENANCE INSTRUCTIONS MANUAL
www.victaulic.com
VICTAULIC IS A REGISTERED TRADEMARK OF VICTAULIC COMPANY.
REV_A