NOTICE
• To prevent air from entering the tee while
the bleeder tube is removed and the plug
is installed: Hold the 4-way valve in the
“shifted” position by pressing in on the
rubber boot on the end of the valve. Keep
the rubber boot depressed until the plug
is installed and tightened.
12. Repeat steps 4 – 11 for bleeding air from
the tee at the top of the hydraulic cylinder
port.
13. Bring the hydraulic oil level up to
1 – 2 inches/25 – 50 mm from the
top of the tank. Refer to the applicable
“Recommended Lubricants” table for the
proper hydraulic oil.
RECOMMENDED LUBRICANTS
BEARING AND SLIDE GREASE
(General Purpose EP Lithium Base Grease)
Manufacturer
Product
BP Amoco
Energrease LC-EP2
Gulf Oil Corp.
Gulfcrown Grease EP#2
Lubriplate
No. 630-2
Mobil Oil Corp.
Mobilux EP2
Pennzoil Products Co.
Pennlith EP 712 Lube
Shell Oil Co.
Alvania EP2
Sun Refining
Sun Prestige 742 EP
Texaco Inc.
Multifak EP2
GEAR OIL
Refer to the tag located on the gear reducer
HYDRAULIC OIL
(High Pressure, Anti-Wear/Anti-Foam Hydraulic
Oil ISO Grade 32)
Manufacturer
Product
BP Amoco
Energol HLP-HM32
Gulf Oil Corp.
Harmony 32 AW
Kendall Refining Co.
Kenoil R&O AW-32
Lubriplate
HO-o
Mobil Oil Corp.
Mobil DTE 24
Pennzoil Products Co.
Pennzbell AW32
Shell Oil Co.
Tellus 32
Sun Refining
Survis 832
Texaco Inc.
Rando
PARTS ORDERING
INFORMATION
When ordering parts, the following information
is required for Victaulic to process the order and
send the correct part(s). Request the RP-VE460
Repair Parts List for detailed drawings and parts
listings.
1.
Tool Model Number – VE460
2. Tool Series Number – The serial number
can be found on the side of the tool on the
nameplate
3. Quantity, Part Number, and Description
4. Where to Send the Part(s) – Company
name and address
5. To Whose Attention to Send the Part(s)
6. Purchase Order Number
7.
Billing Address
Parts can be ordered by calling 1-800-PICK VIC.
TM-VE460_53
TM-VE460
OPERATING AND MAINTENANCE INSTRUCTIONS MANUAL
www.victaulic.com
VICTAULIC IS A REGISTERED TRADEMARK OF VICTAULIC COMPANY.
REV_A