5
Assembly & Use Instructions
Please make sure you have read through the sections -
Operating Precautions (p. 2) and Preparing Specific Fruit
Types (p. 4) - before assembling and using your juicer.
Juicer Assembly & Use:
1.
Remove your new Victorio Steam Juicer from the box and
packaging and check that all items are there and in good
condition. Refer to the diagram on p. 1 for help, if needed.
2.
Wash all parts of the juicer thoroughly by hand, including
the hose and clamp, in warm soapy water and rinse carefully.
3.
Once clean, take the water pot and fill it with 5 quarts of
fresh water and place it on your stove top.
4.
Next, place the juice kettle on top of the water pot so the
juice hose can fall lower than the juice kettle. If the hose is
raised too high, the juice will not drain properly.
5.
Squeeze the clamp and slide it to the center of the hose.
(See diagram below.)
6.
Then, place the colander on top of the juice kettle and fill
it to the top with previously prepared fruit. (Refer to p. 4
for proper fruit preparation methods). The colander hold
approximately 8-9 quarts of fruit pieces.
Make sure the
fruit does not overflow the colander.
