Quartz Infrared Zone Heaters
The following information should be considered when installing Quartz Infrared
Heaters.
Installation should always be carried out by a qualified electrician or a competent person
in accordance with current electrical regulations, protected by a suitably rated isolator
and fuse. If using MCB’s type3 or typeC must be used.
The heaters should always be installed using the mounting brackets provided to
ensure adequate clearance from the wall.
A minimum air gap of 450mm should always be allowed between the top of the
heater and the ceiling or roof.
A safety distance of 1mtr should always be left in front of a 1.5KW heater. Heaters
of 3KW and 4.5KW should have a safety distance of at least 1.5mts and the 6KW
heater leave 2mts.
You also should ensure no flammable material could come into contact with the
heater.
Heaters should not be installed in areas where hazardous vapours may be present
as defined in BS5345
It is recommended the heaters be operated with a guard in front of the lamp and
should always be fitted to units mounted below 2.2mtrs.
The heater should only be installed in an indoor or weather protected environment.
The essential element of the heater is a halogen filled quartz linear lamp with a tungsten
element. This operates at about 2200
C and has a filter to stop most of the white light
and emit short wave infrared radiant heat. The lamp operates at full infrared output
almost instantly and emits radiant energy at 1.2microns.
Quartz heaters are recommended by The Electricity council and Building Services
Research Association for General space heating, Zone heating and localised spot
heating.
This product conforms to EU Directive 2002/96/EC.
This appliance bears the symbol of the crossed waste bin. This
indicates that, at the end of its useful life, it must not be disposed of
as domestic waste, but must be taken to a collection center for waste
electrical and electronic equipment. It is the user's responsibility to
dispose of this appliance through the appropriate channels at the
end of its useful life. Failure to do so may incur the penalties
established by laws governing waste disposal.
HeatLight Technology
Quartz Infrared
HLQ Series Heating
VICTORY (HeatLight Technology)
Unit 36, Orbital 25 Business Park
Dwight Road
Watford
WD18 9DA U.K.
Tel: +44 (0) 1923 804080
Fax: +44 (0) 1923 804081
www.heatlight.com
Info@heatlight.com
INSTRUCTIONS SHOULD BE CAREFULLY READ BEFORE
INSTALLATION AND RETAINED BY THE USER.
