SUNSET |
SAFETY WARNING:
Never put your hand into area housing the fan while the fan is operating!
For optimal operation, clean range hood and any filter/grease tunnel/oil container regularly. Regular care will
help preserve the appearance of the range hood.
Cleaning Exterior surfaces:
•
Clean periodically with hot soapy water and clean cotton cloth. Do not use corrosive or abrasive detergent
(e.g. Comet Power Scruv
®
, EZ-Off
®
oven cleaner), or steel wool/scoring pads, which will scratch and damage
the stainless steel surface. For heavier oil use liquid degrease such as “Forumla 409
®
” or “Fantastic
®
” brand
cleaner.
•
If the hood looks splotchy (stainless steel hood), use a stainless steel cleaner to clean the surface of the
hood. Avoid getting cleaning solution onto or into the control panel. Follow directions of the stainless steel
cleaner. CAUTION: Do not leave on too long as this may cause damage to the hood finish. Use a soft towel
to wipe off the cleaning solution, gently rub off any stubborn spots. Use a dry soft towel to dry the hood.
•
After cleaning, you may use non abrasive stainless steel polish such as 3M
®
or ZEP
®
, to polish and buff out
the stainless luster and grain. Always scrub lightly, a with clean cotton cloth, and with the grain.
• DO NOT allow deposits to accumulate or remain on the hood.
•
DO NOT use ordinary steel wool or steel brushes. Small bits of steel may adhere to the surface and cause
rusting.
•
DO NOT allow salt solutions, disinfectants, bleaches, or cleaning compounds to remain in contact with stain-
less steel for extended periods. Many of these compounds contain chemicals, which may be harmful. Rinse
with water after exposure and wipe dry with a clean cloth.
Cleaning Aluminum Grease Filter:
•
Filters should be cleaned after every 30 hours of use.
•
Remove and clean by hand. Spray “Formula 409
®
” or equivalent degreasing detergent and leave to soak if
very dirty. Dry the filters and re-install before using the hood.
Replacing Filters:
•
Should filters wear out due to age and prolonged use, please contact Victory Range Hoods for replacement
filters.
Replacing the light bulb:
•
This range hood uses LED bulbs (please refer to the actual specification of the hood purchased):
USA/Canada: LED 5.5W Type GU10 120V
•
Make sure the range hood is unplugged or turn OFF breaker.
•
Make sure the lights are cool to touch, carefully put pressure on the bulb and turn counter-clockwise to
loosen and remove. Install a new light bulb and carefully press and turn clockwise to secure the bulb in place.
•
Turn ON breaker and range hood to test for operation.
17
MAINTENANCE
