| SUNSET
Advanced Preparations:
•
Be familiar with the controls of the range hood by reading through Range Hood Operations.
•
Place the range hood on a flat, stable surface. Connect the range hood to a designated standard
outlet (please refer the product label for the suitable voltage of this unit) and turn on the range hood.
Verify all operations of the range hood by referring to Range Hood Operations. Place all supplied
parts and required hardware on a flat, stable surface and verify the existence of all supplied parts.
•
Carefully remove the white or blue plastic protective coat from the range hood.
Preparations:
NOTE: To avoid damage to your hood, prevent debris from entering the vent opening.
•
Decide the location of the venting pipe from the hood to the outside. Refer to Venting Methods.
•
A straight, short vent run will allow the hood to perform more efficiently.
•
Try to avoid as many transitions, elbows, and long run as possible. This may reduce the performance
of the hood.
•
Using 45 degee elbows is better than using 90 degree elbows.
•
IMPORTANT: Peel white plastic protective coat off the hood, if any.
•
Use aluminum tape to seal joints between pipe sections.
8
PREPARATION
