3
EN
ES
FR
1. Quick user guide
GROUNDING AND AC POWER CORD CONNECTION INSTRUCTIONS – Charger should be grounded to
reduce risk of electric shock. Charger is equipped with an electric cord having an equipment-grounding
conductor and a grounding plug. The plug must be plugged into an outlet that is properly installed and
grounded in accordance with all local codes and ordinances.
DANGER – Never alter AC cord or plug provided – if it will not fit outlet, have proper outlet installed by a
qualified electrician. Improper connection can result in a risk of an electric shock.
This appliance is rated more than 15 amperes and is for use on a circuit having a nominal rating of 120 volts
and is factory-equipped with a specific electric cord and plug to permit connection to an acceptable electric
circuit. Make sure that the charger is connected to an outlet having the same configuration as the plug. No
adapter should be used with this charger.
A.
Connect the charger to the battery or batteries (see figure 1).
B.
Connect the charger to the wall socket. The BULK LED will indicate that the mains cable is connected to the
wall socket.
C.
If required, press the MODE-button to select another charging algorithm (the charger remembers the mode
when disconnected from the mains and/or the battery).
If reconditioning is selected, the RECONDITION LED will be on, and will flash when reconditioning is active.
The charger switches to NIGHT by pressing the MODE button during 3 seconds. The NIGHT LED will turn on.
The NIGHT mode automatically ends after 8 hours, and can be ended earlier by again pressing the MODE button
during 3 seconds.
The charger switches to LOW by pressing the MODE button during 6 seconds. The NIGHT LED will blink twice
per second. The LOW mode remains activated until the MODE button is pressed again during 6 seconds.
When NIGHT or LOW are on, the output current is reduced to max. 50% of the nominal output and the charger
will be totally noiseless.
D
. The battery is about 80% charged and ready for use when the absorption LED switches on.
E.
The battery is fully charged when the FLOAT or STORAGE LED is on.
F.
Stop charging at any time by interrupting the AC supply.
Figure 1
