11
E
N
N
L
D
E
Peak Power Pack FAQ List
Subdivided into:
I. Charging
II. Maintenance
III. Use
IV. Technology
V. Installation/Connection
VI. Interesting facts
We obviously recommend the "future" Victron Energy Peak Power Pack user to
carefully read the manual so as to make optimal use of the Victron Energy PPP. The
following FAQ list is to be used as a supplement to the manual.
Question
Answer
I. CHARGING
1.
How much does a PPP demand from
the car's dynamo?
Max. 5A. This depends on the
voltage.
2.
How can the PPP be charged?
a. Using the included 230V charger
(12V, 1A). Duration approx. 14 hours
b. Using a solar panel. The device
will automatically transform excess or
insufficient voltage into the correct
charge voltage. Charge duration
approx. 4.5 hours for a 30W panel in
full sunlight. The PPP checks if the
solar panel is delivering sufficient
power every fifteen minutes. This
should be at least 200 milliamperes,
which means there has to be
sufficient sunshine. As long as the
PPP does not receive 200 mA, it will
not be charged.
c. From the car. The PPP will charge
with the correct charge voltage by
means of the built-in converter.
Charge duration from empty to fully
charged approx. 4 hours (from empty
to 100% charged).
3.
Is the PPP already fully charged at the
time of purchase?
No.
4.
To what extent and/or to what
percentage is the PPP factory charged?
60%..80%
5.
How many Amperes are at least
required in order to charge the PPP at
the camping site?
The mains adapter uses a maximum
of 0.08A (which is extremely low). So
1A is more than sufficient.
6.
Can the PPP be charged both by
means of a solar panel and a car
charger?
No, if the PPP is charged by means
of a solar panel, it cannot also be
charged by means of the car.
However, a combination with the
Summary of Contents for Peak Power Pack
