Installation & operation manual
12
victr on ener gy
B L U E P O W E R
Connect to the battery
15 mm
5/8"
20 mm
6/8"
1. If necessary, adjust the length of the
bus wires at the main fuse box.
2. Remove the cover of the main fuse
box.
3. Loosen the screw to remove the wire
on the fuse.
4. Cut the wire.
5. Remove 15 mm (5/8“) of the
insulation at the end of the wire. Use
the cable cutter to cut the insulation.
6. Place the wire back on its place.
7. Tighten the screw to secure the wire.
8. Clamp the bundles of + (red) and –
(black) battery wires with at least
20 mm (6/8") distance in between.
9. Connect the red cable to the
+
terminal on the battery.
10. Connect the black cable to the
-
terminal on the battery.
Note:
Do the procedure for one wire
at a time.
Warning!
Follow the instructions
properly to reduce the risk of
future shortcut with possible
fire.
Warning!
Make sure there is no risk of
physical damage for the
cables. In case there is a risk,
protect the cables with
grummets or equivalent.
