SnapShot ANPR Bollard Camera Installation Guide
Page 7 of 12
4. Connections
There are two main electrical connections to the standard bollard, namely
video and power. The dual version of the camera also has a second video
output.
Connect the incoming 24v ac supply to
the push terminals marked “24V AC
IN”. The supply should be capable of
delivering 1 amp maximum.
The video output from the ANPR
camera is always taken from the BNC
connector within the junction box.
For the Dual version of the bollard, a
second video output is provided for the
colour overview camera. This is
normally taken directly from the rear of
the overview camera itself (see below).
Note that some overview cameras have no BNC connector and a
composite cable will be pre-wired to the junction box. For these models the
overview video should be made to the BNC connector in the junction box.
Overview
zoom & focus
controls
Overview
video
connector
