- 5 -
Apocalypse 3D User Guide
1. Switch off your computer, monitor, and any hardware devices such as printers connected
to your computer. Leave the power cable connected to the power outlet so that your
computer is grounded.
2. Remove the computer’s cover. You may need to refer to the documentation supplied with
your computer for instructions on how to do this.
3. Locate an empty PCI bus expansion slot and remove the slot cover. Keep the screw, you
will need it later to secure the card.
4. Touch the bare metal chassis of your computer with the back of your hand to discharge
any static that may have built up on you or your clothes.
5. Align Apocalypse 3D with the slot you have chosen. Firmly press it into the slot, as shown
in the diagram below. You will need to use some pressure to push the card into position,
but do not use excessive force.
