VideoProtects VP220D, Installation Manual

VP220D Installation Guide

    |    

6

430751-081 (Rev. 8/21) Copyright 2021 VideoProtects Incorporated. All rights reserved.

Step 4 –

 Connect power supply

There are three ways to provide power to the camera:

1)  Quick plug-in OBD-II power cable adapter (ordered separately)

  If using the OBD-II power supply connection, plug the power box cable into the camera.  

Then, connect the OBD-II quick plug to the power box cable. Route the assembled cable  

up under the headliner, and down the A pillar into the dashboard area near the OBD-II port  

on the vehicle. Plug the OBD-II quick connector into an available OBD-II port. Secure the  

cables under the dashboard with zip ties.

NOTE:

 An OBD-II T harness (ordered separately) will be required to provide multiple  

OBD-II ports for connecting the camera and a GO device.

2)  Quick plug-in 9 pin power cable adapter (ordered separately)

If using the 9-pin power supply connection, plug the power box cable into the camera.  

Then, connect the 9-pin quick plug to the power box cable. Route the assembled cable 

up under the headliner, and down the A pillar into the dashboard area near the 9-pin port  

on the vehicle. Plug the 9-pin quick connector into an available 9-pin port.

NOTE:

 A 9-pin T harness (ordered separately) might be required to provide the appropriate 

ports for connecting the camera and a GO device.