Page 5 MICRODEC485 9951
Insertion of termination resistance or serial line RS485
-
if the receiver is at the end of the serial line in RS485, the jumper JP1 must be in A position (termination resistance
inserted)
-
if the receiver is not at the end of the serial line in RS485, the jumper JP1 must be in B position (termination
resistance not inserted)
MICRODEC485 INSTALLATION STAGES
(5)
(2)
(4)
(3)
(1)
FIG. 1
FIG. 2
(1) housing bottom
(2) support plate
(3) fastening screws
(4) MICRODEC485
(5) fastening spacers
INSTALLATION
Fasten the support plate (2) to the housing
bottom (1) by the fastening screws (3).
Push the MICRODEC485 (4) on the
fastening spacers (5), fixing it to the plate
(FIG.2).
