Instruc
tion manual - English - EN
11
MNVCNXM36_2051_EN
6.3.2 120/230Vac version
Nominal section of the cables used: from
0.2mm² (24AWG) up to 2.5mm² (13AWG).
When the power supply voltage is 120/230Vac the
circuit will be connected by the terminals shown.
OUT 120/230Vac
IN 120/230Vac
Heater OUT 120/230Vac
Fig.
6
6.3.3 Hi-PoE version
Connect the PoE cable from the Power Injector to the
J1 connector.
Connect the camera to the J2 connector.
J2
J1
Fig.
7
6.3.3.1 Power consumption configuration
Before powering the device, you must set the
maximum power consumption of the housing
operating on dip switch SW1.
SW1
Fig.
8
POWER CONSUMPTION CONFIGURATION
SW1
Maximum power
POE
PoE, class 3 (13W max)
POE+
Hi-PoE, class 4 (25W max)
Tab.
3
