Adjusting Sensitivity
The Wave To Play has four sensitivity settings.
The thicker and denser the material you place in
front of the sensor, the higher the sensitivity
setting should be. The Wave To Play is capable of
sensing movement up to 3” through wood, plas-
tic or glass. To adjust sensitivity, simply press
either the “Min” or “Max” button on the side of
the Wave To Play. Note: The sensor is on the
bottom of the case where the mounting holes
are located.
Connections, File To Play, Power & Trigger
• Either I/O jack can be used for Videotel Media
Players, RS232, TTL or dry contact trigger
• When the Wave To Play is connected the
“Power” LED will illuminate green
• When the Wave To Play senses a hand in close
proximity the “Trigger” LED will illuminate blue
TO
For additional instructions, videos and
help with connecting the Wave To Play
to our networked players or to a 3rd
party player, please scan QR code
Connecting Dry Contact Switch Terminal
The Wave To Play can be used as a dry contact
switch. When the Wave To Play is triggered an
internal relay is switched from the normally open
position (N.O.) to normally closed (N.C.) for 1
second. Simply connect the 6 pin I/O cable with
the orange 4 conductor terminal block (shown
below) into the Wave To Play. The terminal block
is labeled and requires 5VDC on the outside
connections. The 2 inside connections are the
switch.
Ground
Switch
Switch
+5VDC
