NOTICE!
Damage to objects due to damages press jaws
Using a defectively, incorrectly dimensioned, or worn press
jaw may result in incorrect pressing.
– Before using the press jaw, check it for visible defects.
– Only use faultless press jaws of a suitable size.
The press jaw must be able to lock properly during
pressing.
–
Ensure that there is sufficient room at the pressing point.
–
Keep the press jaw contour and the area around the
pressing point free of dirt.
Requirements:
n
The press machine is ready for operation; the green LED is lit.
n
You have properly inserted a press jaw.
Check whether the nominal width of the press connector matches
the nominal width of the press jaw.
Fit the press machine with the press jaw inserted accurately and at
a right angle to the pipe axis on the press connector.
Keep the Start button pressed until the automatic process starts.
ð
As soon as the press machine builds up pressing force, it
automatically carries out and completes pressing until the
entire press stroke has been carried out.
The pressing is completed after full retraction of the roller head.
Open the press jaw and loosen it from the press connector.
In case of interruption of the power supply during pressing,
press the button for manual release to return the roller head
to its initial position. Next, remove the incompletely pressed
connector from the installation and repeat pressing with a
new connector.
90°
Handling
Pressgun Picco press machine set
17 from 22
