11
IM-HC 599871 0321 RABS
Product Information
NOTICE!
This equipment has been tested and found to comply with the
limits for a Class B digital device, pursuant to part 15 of the FCC
Rules. These limits are designed to provide reasonable
protection against harmful interference in a residential
installation. This equipment generates, uses and can radiate
radio frequency energy and, if not installed and used in
accordance with the instructions, may cause harmful interference
to radio communications. However, there is no guarantee that
interference will not occur in a particular installation. If this
equipment does cause harmful interference to radio or television
reception, which can be determined by turning the equipment off
and on, the user is encouraged to try to correct the interference
by one or more of the following measures:
–
Increase the separation between the equipment and receiver.
–
Connect the equipment into an outlet on a circuit different
from that to which the receiver is connected.
–
Consult the dealer or an experienced radio/TV technician for help
NOTICE!
This device complies with part 15 of the FCC rules.
Operation is subject to the following two conditions: (1) This
device may not cause harmful interference, and (2) this
device must accept any interference received, including
interference that may cause undesired operation.
2.2 Intended Use
NOTICE!
All RABS components were designed to be plug and play by
using non-interchangeable connections.
However, the end user is responsible for acquiring two
conductor 18 AWG cable for connecting RABS to a heat
source. The total length of this cable must not exceed 32 feet.
The Radiant Auto-Balancing System (RABS) is an energy efficient digital
zone controller for residential radiant heating systems. It offers four
progressively efficient operation methods (from local push-button to remote
operation via end device) that can heat zones up to a set point of 86° F.
