57
IM-HC 599871 0321 RABS
Software Set-Up Procedures
5.2.2 Setting Up a WLAN Module
X
Open the WLAN network overview at the end device.
Figure 22: Example of a WLAN network overview at the end device
X
Among the indicated network connections, select the desired
control unit, e.g. “rabs-1705150165”.
To establish the connection, you will need the serial number and
password of the WLAN module. This data is to be found on a label on
your WLAN module.
X
Enter the serial number and the WLAN password.
Z
The WLAN connection to the control unit is executed as a point-
to-point connection.
5.2.3 Starting the Operating Software
Installation and set-up cannot be carried out using a smart
phone. If possible, use a computer or tablet for the steps
described in the following.
You can access the operating software of the control unit via a browser
on your end device.
X
Open the browser.
X
Type 192.168.1.1 in the URL address line and press Enter to confirm.
Z
The window for entering company data pops up.
