34
Descaling
Repeat the above steps two or three times
until the descaling solution inside the
water container has been completely
emptied through the nozzle.
After descaling, thoroughly rinse out the
water container (7) and fill it with fresh
water. Turn the machine back on and
rinse it thoroughly by discharging water
(approx. 1.4 litres) through the steam/
hot water nozzle.
In this manner you will eliminate any
residues that might alter the taste of the
coffee.
The machine is again ready for use. To
clear the message
d e c a l c i f y
press the
MENU/OK
key to go back
to the programming mode. With the
∧∧∧∧∧
or
∨∨∨∨∨
key, selection the function
s i g n a l . d e s c a l .
and activate it with the
MENU/OK
key. The messages
q u a n t i t y w a t e r
n o t r e a c h e d
and
l e f t q u a n t i t y
l 1 3 0
will be displayed in turn.
Press the
MENU/OK
key. The
message
r e s e t d e s c a l i n g
y e s
will appear.
Press the
MENU/OK
key again to
clear the scale meter.
9.2
Automatic descaling
Before starting the integrated descaling
program, prepare the descaling solution
in a proportion of 1:1 according to the
directions on the package and pour it
into the water container.
Press the
MENU/OK
key. With the
∧∧∧∧∧
or
∨∨∨∨∨
key, select the
d e s c a l i n g
function and activate it with the
MENU/
OK
key.
Place a large container (min. 1 litre
capacity) under the steam/hot water
nozzle and slowly turn the knob (6). The
message
m a c h i n e i s
d e s c a l i n g
will be
displayed to indicate that the automatic
descaling cycle has begun.
It will be carried out at intervals until the
message
d e s c a l i n g
f i n i s h e d
appears.
Again turn the knob (6) and press the
MENU/OK
key. The message
r i n s e m a c h i n e
will appear.
Now you must thoroughly rinse out the
water container, fill it with fresh water and
place it back in the machine.
Once again, place a large container
under the steam/hot water nozzle and
slightly turn the steam/hot water
knob.
Allow the entire contents of the water
container to flow out slowly through the
nozzle until the message
r i n s i n g
f i n i s h e d
is displayed. Close the
knob (6).
At the end of the descaling operation,
exit the program by pressing the
MENU/OK
key.
The message
w a r m i n g u p
will
appear.
Note: the duration of the
descaling and rinse cycle is about
40 minutes.
Important: regular descaling
of the machine protects it from
damage that may be costly to
repair.
The warranty does not cover any faults
caused by failure to descale the
machine, improper use or non-
compliance with the operating
instructions.
i
i
