Identify the place on the rear part of the cabin where the tank will be
installed.
Use the support plate to mark the points of attachment to the cabin.
ALLWAYS OVER THE WELDING LINES prove with a 5 mm.
diameter drill bit and then perforate with a 9 mm. drill bit.
If using neoprene rivets, use a 12 mm. drill bit.
12 mm.
Important:
When using the 5 or 9 mm. drills bits, use a depth stop,
to prevent damaging the inside upholstery.
Neoprene rivets are used in units with fibreglass cabins.
Introduce and affix the threaded rivets provided.
For neoprene rivets insert them (manually) up
to the brim. Then adjust the screws.
Install the water tank support plate to the cabin taking into account
that there must be a separation of 10 mm. between the plate
Place the polyester foam washers in order to avoid water or
humidity filtrations.
9 mm.
and the cabin. Use the spacers provided.
