Safety instructions
VITOBLOC 200
CHP unit accessory • Operating and installation instructions • Remote reset
3
5838316
GB
1
Safety instructions
General
These operating instructions contain basic information that must be observed
when installing and operating the communication module. They must therefore
be read by the installer and relevant qualified technician(s) prior to installation
and commissioning. They must always be available at the system.
Identification
of safety instructions
Failure to observe the safety instructions identified with this hazard
symbol in these installation and operating instructions may result in
risks to persons.
Failure to observe the safety instructions identified with this symbol
may result in risks for the device or the system and its functions.
This symbol indicates information that will simplify work and ensure
safe operation.
Personnel
qualifications
The personnel designated to operate and install this equipment must have the
appropriate qualifications to undertake this work. The system operator is
responsible for ensuring that this is the case.
The safety instructions listed in these operating instructions must be observed,
as must all applicable national regulations for accident prevention and any in-
house working, operating or safety instructions issued by the operator.
Risks from
failure to observe the
safety instructions
Failure to observe the safety instructions may result in risks to persons as well
as to the environment and the system.
LIABILITY!
The manufacturer will not accept any liability if these safety
instructions are not observed.
In particular, failure to observe these instructions may pose the following risks:
•
Failure of important system functions
•
Electrical hazards presenting a danger to persons
Safety instructions for the
operator
(risk analysis according to
EN 12100)
Electrical hazards
Hazards arising from electrical current, e.g. as a result of removing safety
covers, must be prevented.
Safety instructions for
maintenance, inspection
and installation work
The operator must ensure that all inspection and installation work is carried out
by authorised, qualified personnel who have used the operating instructions to
acquaint themselves with the way the remote reset module works.
Directly after work has been completed, all safety and protection equipment
must be replaced and returned to full function.
Unauthorised
modifications and
production of spare parts
The remote reset module must not be converted or modified in any way.
Original spare parts and accessories authorised by the manufacturer are
important to ensure safety. Use of other parts can void the liability for any
resulting losses.
