4
5724 267 v1.0
Safety
Important regulatory and safety requirements
Instructing the system user
The installer of the system is responsible to ensure the
system operator/ultimate owner is made familiar with
the functioning of the system, its activation, and its
shut-down.
Initial start-up
Initial start-up must be performed by a qualified heating
contractor. Completion of the Maintenance Record by the
heating contractor is also required.
Working on the equipment
The installation, adjustment, service, and maintenance of
this equipment must be done by a
licensed professional
heating contractor
who is qualified and experienced in the
installation, service, and maintenance of hot water heating
systems. There are no user serviceable parts on this
equipment.
Ensure
main power
supply to equipment, the heating
system, and all external controls has been
deactivated
.
Take precautions in all instances to avoid accidental
activation of power during service work.
Technical literature
Literature applicable to all aspects of the Vitosol 100-F,
200-F or Vitosol 200-T, Vitosol 300-T:
-
Technical Data Manual
-
Installation Instructions
-
Start-up, Service and Operating Instructions
-
System Design Guidelines
u
The following topics must be covered:
Proper system operation sequence.
Explain the equipment.
Demonstrate an emergency shut-down, what to do
and what not.
Explain that there is no substitute for proper
maintenance to help ensure safe operation.
u
The Maintenance Record is located in the Vitosol
Start-up, Service and Operating Instructions.
u
Please carefully read this manual prior to attempting
start-up, maintenance or service. Any warranty is null
and void if these instructions are not followed.
For information regarding other Viessmann System
Technology componentry, please reference
documentation of the respective product.
Viessmann offers frequent installation and service
seminars to familiarize our partners with our products.
Please inquire.
u
The completeness and functionality of field supplied
electrical controls and components must be verified
by the heating contractor. These include low water
cut-offs, flow switches (if used), staging controls,
pumps, motorized valves, air vents, thermostats, etc.
u
Leave all literature at the installation site and advise
the system operator/ultimate owner where the
literature can be found. Contact Viessmann for
additional copies.
In the lower part of the building, install an electrical
conductor on the solar circuit’s piping system in
compliance with local regulations.
Connection of the solar system to a new or existing
lightning protection or the provision of local grounding
should only be carried out by a licensed professional, who
must take into account the prevailing conditions on site.
g
Grounding/lightning protection of the solar system
The installation and startup of the solar station as well as the connection of electrical components require technical
knowledge commensurate with recognized vocational qualification as a fitter for plumbing, heating and air conditioning
technology, or a profession requiring a comparable level of knowledge [specialist].
The following must be observed during installation and startup:
»
Relevant local and national regulations
»
Accident prevention regulations of the professional association
»
Instructions and safety instructions mentioned in this manual
