22
Setting an individual time program
Setting time phases
In the preset time programs
"Prog 1"
to
"Prog 3"
, the day is split into 6 time
phases.
For every enabled time phase, the fol-
lowing must be entered:
■ Start time
■ Stop time
■ Operating modes
"Enable"
,
"Block"
You can select time phases for several
days (day groups) or for individual
days:
■
"MO–SU"
for the same time phases
every day of the week
■
"MO–FR"
for the same time phases
Monday to Friday
■
"SA–SU"
for the same time phases
Saturday and Sunday
■
"SINGLE DAY"
different time phases
for individual days
Note
Settings for individual days take prior-
ity over settings for several days.
0
1.
Open the flap.
0
2.
Press
twice
.
0
3.
With / select
"Settings"
.
0
4.
Confirm with
OK
.
0
5.
With / select
"Programs"
.
0
6.
Confirm with
OK
.
0
7.
Select the program you want to
change with / (e.g.
"Prog 1"
).
0
8.
Confirm with
OK
.
0
9.
Select
"DHW"
with / .
10.
Confirm with
OK
.
11.
With / select
"Set"
.
12.
Confirm with
OK
.
13.
Set the required group of days/
single day with / .
14.
Confirm with
OK
.
15.
Set the required time phase or ini-
tially the required day with / .
16.
Confirm with
OK
.
17.
With / set the required start time,
stop time and the operating mode
(e.g.
"Lock"
) one after the other.
18.
Confirm respectively with
OK
.
19.
Proceed as described in points 15
to 18 to set further time phases.
Note
Should gaps be created between
the time phases, these are closed
automatically by extending the pre-
vious time phase.
DHW heating
Selecting the time program
(cont.)
5699 292 GB
